![]() Only once the playback is activated fully will it be coloured When one of the main faders has HTP levels active then it is coloured If the "Flash activates" option is set then pressing the FLASH button Or if the "Fader activates" option is set by moving the fader upwards. LTP channels will be activated in the normal way – i.e. Output regardless of any other higher priority faders with "All chans The "HTP always active (Use HTP)" has priority over the "All chansĬontrolled LTP" option – therefore HTP channels on playbacks will be Times will still be used when changing steps – i.e. If the Cue Stack has multiple steps then delay and fade Pressing the FLASH button will not use any specified Intensity delay orįade times. If a Playback is set to "HTP Always Active" then raising the fader or They are notĪffected by pressing the RELEASE or the SHIFT RELEASE buttons. Only be released when the fader is taken back down to 0. Regardless of the other activate options on the Cue Stack. Output whenever the fader is above the activation point (defaults 0) ![]() When this option is set, then HTP channels on the playback will be ![]() It is possible to make a Playback so that theĪctivation of the Playback is separated from the operation of the HTPĬhannels using the "HTP always active (Use HTP)" in Cue Stack options, Thus that Playback will exclusively control the levels of all channelsīy default HTP channels programmed in a Playback only affect output when Then all channels controlled by that Playback are considered to be LTP. LTP" then when that Playback is activated as the last touched playback Note that if a Cue Stack on a Playback is set to "All chans controlled The FX is added to the highest channel value. One playback could have an ambient level whilst another has a dimmerĬhase. Program one playback with channel values and one with FX. The programmer and preset faders have no effect on HTP output.įX and channel values are handled independently enabling operators to Playbacks with a FLASH button pressed affect the HTP output. The HTP channels from all other playbacks are disregarded. In SWAP mode when a FLASH button for a playback is pressed then The console supports a powerful swap mode selected through the ADD/SWAPīutton. If the "Programmer overrides HTP chans" option is enabled then any HTPĬhannels in the programmer will override channels on the playbacks.Ĭhannels on preset faders still affect the output. Simple way - the highest value from all the playbacks, the programmerĪnd the preset faders is the value that is output. The console handles HTP (Highest Takes Precedence) channels in a very
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |